PAIRING: Reconnect HRM, PM or Trainer when its go to sleep and wakeup during training
When HRM, PM or Trainer go to sleep and wakeup during training (e.g. Take a brake) often then its dont reconnect again automaticaly.
Defore the change pairing interface thats problem are absent!
The new pairing interface often forgets previously established connections!
Alexandre Petchnikov
shared this idea
-
Barry Gaunt commented
This happens with both my Polar H10 and Garmin HRM-Pro devices. This did not happen in earlier versions of TPV so much, if at all. There is only about 1 meter distance between computer with Ant+ dongle and a Garmin Edge 730 which does not lose signal when making a pitstop.
-
Neil
commented
When you leave the room using an ANT+ HRM, connectivity is lost, which is fine. However, when you come back, the HRM does not reconnect and you have to reconnect the HRM via settings.
Annoying when needing a “comfort break” on a long ride and perhaps race stopping if on a tight schedule between warm up and race and you need to fill a bidon,
I’ve created this entry in the system as a previous one had it as one of two things on the same issue.
Original entry was here: https://peaksware.uservoice.com/forums/964442-trainingpeaks-virtual-customer-feedback/suggestions/50783285-hrm-connection