TP Virtual does not detect my ANT+ usb stick
TP Virtual does not detect my ANT+ usb stick if it isn't connected on startup of the software (windows)
It does work fine if the ANT+ adapter is connected during startup.
This is a little annoying as you need to restart the software before being able to use ANT+.
Patrick
shared this idea
-
Maksymilian Kapica commented
While using the program shortly after startup, the ANT+ stick connected via USB was accidentally disconnected due to hardware issues caused by a low-quality USB hub.
After reconnecting the ANT+ stick directly to the computer (without the faulty hub), the program appeared to have no connection issues with the trainer.
However, when attempting to re-pair the devices by following these steps:
1. Unpairing the trainer.
2. Re-pairing the trainer.
The program successfully "paired" the devices (despite what I suspect was no actual communication). Ultimately, power data from the trainer was not transmitted to the program.
Only availale solution is to restart program.Steps to Reproduce
1. Start the program with an ANT+ stick connected via USB, and already paired devices.
2. Start ride
3. Disconnect the ANT+ stick during operation.
4. Reconnect the ANT+ stick.
5. Attempt to unpair and re-pair the trainer.
6. Observe whether the trainer transmits data to the program.I have attached the relevant logs where the issue occurred for further analysis.