Settings and activity
6 results found
-
4 votes
An error occurred while saving the comment 
Stefano Gerardi
shared this idea
·
-
148 votesStefano Gerardi
supported this idea
·
-
101 votesStefano Gerardi
supported this idea
·
-
16 votes
Many thanks for your suggestion and support for TrainingPeaks Virtual.
In general, some degree of gamification can be good, but we need to be careful not to go too far - for example, we would not want to do anything that encouraged an athlete to train when it would be better for them to be resting etc.
It's therefore an area we will certainly be looking at, but at this stage it's unclear what changes we may or may not make.
Stefano Gerardi
supported this idea
·
-
7 votesStefano Gerardi
supported this idea
·
-
3 votesStefano Gerardi
supported this idea
·
Dear all,
I would like to provide some additional details based on today’s training session (2024/11-19).
Throughout the entire session, I didn't touch any buttons on the display, and everything worked perfectly.
In the last 10 minutes, I made some tests.
I touched the display, and the all controls (power, erg, turn, view and so on) appeared.
These controls work perfectly and disappear a few seconds after being used.
Then I touched again the display in the lower left corner, the “menu” and “workout” commands appeared.
If you don't touch these buttons (if visible), they disappear after about 10 seconds.
But... if you touch the "menù" or the "workout" commands to access and drill to their submenus... when you come back to the ride, the two commands no longer disappear and they stay fixed ("ON position") in the lower left corner.
Therefore, to ride your training, you don't have to drill the "menù" or "workout" buttons during the session!
You can touch them only at the end of the ride to save the exercise and exit definitively.
Please find screenshots and log attached (for log have a look strartinf from 08:56:32.199 when I started my "menù" test.
Best regards.